Embroidery Advisor Presents : Valentine Card Applique In The Hoop Project February 8, 2014 starbird99 Comments (1) Not rated yet Embroidery Advisor Presents : Valentine Card Applique In The Hoop Project Materials: 1 Valentine Card Applique In the Hoop Embroidery Design 3 Tear Away backing pieces (sized to fit your hoop) Bobbin thread to match the thread color of the last color stop 2 Appliqué fabric pieces - 10” H x 5” W each approximately Velcro Strip 1” square (optional) Spray Adhesive Scissors Step 1: Create your applique pieces. You can create the applique a couple of different ways. If you have software you can print the dielines and create a template. If not, you could also hoop the applique fabric face up and then embroider the dieline file directly on it. Then gently cut along the stitches. Step 2: First hoop 3 pieces of tear away backing in your hoop. Then sew the 1st color stop which is the dieline. (You can now use this as a template to cut both the front and back appliqué pieces if you want.) Step 3: After the dieline has sewn, stop the machine and place the Bottom Front appliqué piece within the dielines. (If you are using your own fabric be sure to use an adhesive spray to keep the fabric in place.) Step 4: Start the machine again and embroidery the design until the next appliqué placement stop. Step5: Remove the hoop from your machine. Do not unhoop the design. Turn the hoop over so you are looking at the back of the design. Step 6: Now place the Bottom Back appliqué piece on the back of the design making sure that the appliqué piece is secure and will not fall off when you return the hoop to the machine. (Use spray adhesive if you are not using the PSA Twill.) Step 7: Carefully return the hoop to your machine and continue embroidering the design. Step 8: Now you should see the dieline for the heart, stop the machine and go to the next step. Step 9: Place the Heart Front appliqué piece within the dielines. (If you are using your own fabric be sure to use an adhesive spray to keep the fabric in place.) Step 10: Start the machine again and embroidery the design until the next appliqué placement stop. Step 11: Remove the hoop from your machine. Do not unhoop the design. Turn the hoop over so you are looking at the back of the design. Step 12: Now place the Bottom Back appliqué piece on the back of the design making sure that the appliqué piece is secure and will not fall off when you return the hoop to the machine. (Use spray adhesive if you are not using the PSA Twill.) Step 13: Carefully return the hoop to your machine and continue embroidering the design. Step 14: Remove the design from the hoop and gently tear away the backing from the bookmark. You may need to trim away any excess backing or stray thread. Step 15: You will also need to remove the tear away backing just below the heart. Step 16: Fold the card in half along the bottom line shown in the picture on the right. Measure about 3” above the bottom of the card. Then fold the heart back along the top line so it is facing up. Step 17: If you want you can cut a little heart out of the Velcro. Then remove the backing from one side and place it on the back of the heart. Then remove the backing from the other side and close the card. (Let the card sit with the Velcro together so that the Velcro adheres to the fabric. See the directions on the Velcro.) Thanks for Reading and have a great Valentines Day! Click Here To View Valentine Card Applique In the Hoop Embroidery Designs Pack (Currently on sale)