 Rank: Member
|
i have a brother pe700 II and when i am embrodering the machine stops and says check thread and it is still threaded i push the start button and it will go for about 30 seconds and then stop again but it is still threaded i have rethreaded it changed needle and changed bobbin check to make sure no lent is in bobbin area what else could i check. any help would be appreciated.
|
|
|
|
|
|
 Rank: Advanced Member Thanks: 2 timesWas thanked: 1 time(s) in 1 post(s)
|
That sounds like a 'sensor' issue. That requires a technician. Sometimes the sensors are too sensitive or just bad.
Pat, The Avid Embroiderer
|
|
|
|
|
|
 Rank: Newbie
|
I have a PE700 that I have used for a couple of years with no problem, and then it started doing the same thing. I have found that just by increasing the upper thread tension one "notch," it stops it from doing that. Just be sure you upper thread tension is not too loose.
|
|
|
|
|
|
| Users browsing this topic |
|
Guest
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.